Line Runner Ridge Community

Line Runner Ridge CommunityLine Runner Ridge CommunityLine Runner Ridge Community

Line Runner Ridge Community

Line Runner Ridge CommunityLine Runner Ridge CommunityLine Runner Ridge Community
  • HOME
  • Gate
  • NEWS
  • COMMUNITY
  • LAKE
  • LRMC
  • Documents
  • More
    • HOME
    • Gate
    • NEWS
    • COMMUNITY
    • LAKE
    • LRMC
    • Documents
  • HOME
  • Gate
  • NEWS
  • COMMUNITY
  • LAKE
  • LRMC
  • Documents

Gate Operation

Normal Operation - 15 Second Delay

You can purchase a remote control (multi-code 308911) inexpensively at Amazon's website ( https://www.amazon.com/dp/B01MXD2AK1 ) or locally (Tractor Supply, Walmart, Lowe's, etc.) as long as it is a 10 pin remote.  The remote will allow you to open the gate without getting out of your car.


  1. Leaving: The gate will automatically open when your vehicle passes the orange post on the right side of the road going out of Line Runner (mountain side).  If your car is too far to the left on the road (valley/stream side), the sensor will not pick up your car and will not open the gate. Tip: You can also use your clicker further up the hill before the orange post to start the gate opening so that it is opened fully by the time you get to the gate. 
  2. Arriving:  Open the gate by keying in the 4 digit code on the keypad or by using your clicker. The gate will open and it will automatically close after 22 seconds.   
  3. Please allow the gate to open all the way! If you “run the gate” (go through it before it is all the way open) you risk damage to your vehicle.    
  4. If you come to the gate and it is open, DO NOT go through, it may close on you.  Press the button on your clicker or key in the code again to add another 22 seconds to the timer.  

Gate blocking a gravel road in a lush green forest.

Gate blocking a gravel road in a lush green forest.

Gate Troubleshooting

How to Troubleshoot the Gate

If the gate is not working and you can’t get in:


Take a cloth, Kleenex, towel, napkin, etc. anything (soft) and clean off :

  1. Wipe the reflector across the road from the hinged side of the gate.
  2. Wipe the eye next to the bottom hinge of the gate.


Ninety percent of the time after you wipe them off, the gate will operate normally. 


After completing the above:

  • Try your clicker or the keypad after cleaning sensors and reflectors.
  • If the above does not work, disengage the operator before pushing the gate open.  If you don’t disengage the operator, you will break the gear box.  If you want to learn how to disengage the operator, please contact the board. It does not take a lot of strength to disengage the operator arm, so everyone can learn how to do this. 


The gear box has been broken numerous times in the past). There is a camera on the gate.  If someone breaks the gear box, whether a part of the community, a visitor or a vendor, they will be responsible for the cost of repairs.


DO NOT PUSH OR PULL GATE OPEN WITHOUT DISENGAGING OPERATOR FIRST


You can purchase a 10-pin remote control (multi-code 308911) from Amazon's website, (Tractor Supply, Walmart, Lowe's, etc) that will allow you to open the gate without getting out of your car. Please contact the board for the required pin settings.


Our thanks to the gate committee for their tireless efforts on the gate.

A gated dirt road entrance to Line Runner Ridge in a wooded area.

A gated dirt road entrance to Line Runner Ridge in a wooded area.

Copyright © 2025 Linerunner Ridge Community - All Rights Reserved.

Powered by